| Drive Size | : | 1/4 in |
| Drive Type | : | Slotted |
| Finish | : | Bright Zinc-Plated |
| Head Size | : | 1/4 in |
| Head Type | : | Hex Washer |
| Material | : | Steel |
| Overall Length | : | 3 in |
| Thread Length | : | 3/4 in |
| Thread Size | : | #10 |
| Thread Type | : | Combination Lead Double |
Malco® Zip-in® Screws are known for their superior quality and is considered by many for being the best screw choice for HVAC metal duct fastening. A unique thread design and quality controlled manufacture spell the Zip-in® sheet metal screw difference. Zip-in® are made with a sophisticated heat treat process which allows the screw to taper to a fine, sharp point without sacrificing critical point strength. A single starting thread is formed down to the very tip of the point and is the source of Zip-in® penetrating power. A second thread above the point engages after initial penetration and drills in the screw double fast. Malco® Zip-in® screws are faster driving, with a greater capacity for fastening heavier gauges of sheet metal than any other self-piercing type. For the best performance, use any Zip-in® Sheet Metal Screw with a Malco® C-RHEX® Cleanable, Reversible Dual Sided Hex Driver.
Malco® Self-Piercing Sheet Metal Screw, #10 Thread, Combination Lead Double Thread, 3 in Overall Length, 1/4 in Head, Hex Washer Head, 1/4 in Drive, Slotted Drive, 3/4 in Thread Length, Steel, Finish: Bright Zinc-Plated
- Undercut - indented hex washer slotted head
- Burr-free
- Full 1/4 in (No. 8) head will not strip out of hex driver opening
- One 1/4 in hex driver accommodates all sizes
- Undercut - always seats flush
- Single starting thread machined down to very tip of screw point
- Instantly penetrates and engages in heavy gauge sheet metal and layered light gauge
- Consistent hard point
- Quality controlled heat treat
- Sharp tapered point will not mushroom or break
- No walking